MI-250 GO-TO
There is a New Question and Answer MI-250 wiki available on this site for MI-250 users
There is a new Question and Answer Gemini wiki for users of the Gemini-1/2 mount controller.
 
 

MI- SD Saddle Plate mounting Hole pattern
On older  MI-250 Go-To mounts.
You will need to make sure that the Saddle plates have the necessary clearance for the knobs. Here is a picture of MI-250 new saddle plate on a older mount. If you purchase a Robin Cassidy Plate it also needs a clearance.  I know this because before my mount was upgraded by Larry, the Robin Cassidy plate it had on it had an adapter plate under it.  If you purchase any adapter plate, make sure it's knobs will clear.

Also, you need to make sure that it is not too wide, so that the clutch screws will clear.  On the newer version of the mount, you want to make sure the clutch knobs will clear.
Web Site © Copyright 2012 MI-250.com  All Rights Reserved